Serie VGE

Grazie a molti anni di esperienza nella costruzione, messa in servizio e manutenzione di compressori per gas naturale, ed alla collaborazione con alcuni distributori, Adicomp ha sviluppato una nuova serie di compressori standardizzata e ad alte prestazioni per alimentare turbine e motori a gas.

COME FUNZIONA
I nostri package di compressione e trattamento del gas naturale sono progettati su uno skid facilmente movimentabile, composto da un gruppo di compressione rotativo a vite a iniezione di olio direttamente accoppiato ad un motore elettrico. Il gas secco viene aspirato e filtrato per poi fluire, attraverso una valvola di controllo, ai rotori. Durante il processo di compressione del gas, l’olio viene iniettato all’interno del pompante per svolgere tre funzioni principali: lubrificazione, tenuta e assorbimento del calore. Dopo la fase di compressione, la maggior parte dell’olio viene rimosso grazie a filtri specifici mentre il gas passa attraverso un raffreddatore d’aria per far in modo che la sua temperatura diminuisca. Una valvola di by-pass meccanica ricircola il gas in eccesso per modulare la portata dal valore raggiunto alla minima velocità del motore elettrico, fino allo 0%. Quando il sistema si arresta, il circuito viene depressurizzato convogliando il gas in un apposito serbatoio di espansione o scaricandolo in atmosfera.

PRSSIONE OPERATIVA
5.5/6 bar(g)

PORTATA
fino a 309 Nm3/h

POTENZA ASSORBITA
fino a 37 kW

REFERENCES

Model UVG315/VG250

Spain

Two screw compressors for biogas upgrading installed inside a container (40’) for a total flowrate of 3800 Nm3/h. One screw compressor for biomethane grid injection, in compliance with the Spain requirements for the GRFD. They are designed in compliance with the European standards for classified Atex zone 2, water-cooled, with outlet gas temperature control, fine filtration and remote control by PLC.
View more

Model ADLR9-45

Turkey

Two of five three stages reciprocating compressors for wellhead gas. Engineered with gas engine and local control panel equipped with PLC and suitable for classified area zone 2. Designed for outdoor installation and with by-pass valve for flow rate regulation.
View more

Model UVG 90

France

Screw biogas compressor for upgrading located in France. Designed for classified Atex Zone 2 for outdoor installation, air-cooled, completed with temperature control, heat recovery and controlled by PLC. It is equipped with fully electrical by-pass system.
View more

Model UVG315

Italy

Screw biogas compressor for upgrading located in Italy. Designed for classified Atex Zone 2 for indoor installation, water-cooled, completed with temperature control, fine filtration and controlled by PLC.
View more

Model UVG355

Netherlands

Screw biogas compressor for upgrading located in the Netherlands. Designed for classified Atex Zone 2 for indoor installation, air-cooled, completed with temperature control, heat recovery and controlled by PLC.
View more

Model UVG110

France

Screw biogas compressor for upgrading located in France. Designed for classified Atex Zone 2 for outdoor installation, air-cooled, completed with temperature control, heat recovery and controlled by PLC. It is equipped with electro-pneumatic by-pass system.
View more

Model UVG110

France

Screw biogas compressor for upgrading located in France. Designed for classified Atex Zone 2 for indoor installation, air-cooled, completed with heat recovery, temperature control and controlled by PLC. It is equipped with mechanical oil shaft seal & pressurized suction condensate drainer.
View more

Model UVG110

Swiss

Screw biogas compressor for upgrading located in Swiss. Designed for classified Atex Zone 2 for indoor installation, water-cooled, completed with activated carbon column, temperature control, fine filtration and controlled by PLC.
View more

Model UVG 200

USA

Screw biogas compressor for upgrading located in USA. Designed in compliance with north american standards, suitable for outdoor installation, air-cooled, completed with electro-pneumatic by-pass system and controlled by PLC.
View more

Model BVG45

Turkey

Screw biogas compressor for upgrading located in Turkey. Designed for classified Atex Zone 2 for outdoor installation, air-cooled, completed with electro-pneumatic by-pass valve, heat recovery and controlled by PLC.
View more

OTHER PRODUCTS

Serie VGE

View more

Serie VG

View more

Serie ADI70/115

View more

Serie BVG/UVG

View more

Contact us

Write us for support or information